Particle Size Improvement and Layer Absorption of Metil Halida MAPbI3 Perovskite Doping Phenethylammonium Iodide (PEAI)

Authors

  • Anla Fet Hardi Anla Department of Physics, Faculty of Mathematics and Natural Sciences, Universitas Andalas, Padang, 25173, Indonesia https://orcid.org/0000-0003-4838-4747
  • Dahyunir Dahyunir Department of Physics, Faculty of Mathematics and Natural Sciences, Universitas Andalas, Padang, 25173, Indonesia
  • muldarisnur muldarisnur Department of Physics, Faculty of Mathematics and Natural Sciences, Universitas Andalas, Padang, 25173, Indonesia
  • Yasir Amrullah Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Andalas, Padang, 25173, Indonesia
  • Siti Naqiyah Sadikin Institute of Microengineering and Nanoelectronics, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor, Malaysia
  • Jaenudin Ridwan Institute of Microengineering and Nanoelectronics, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor, Indonesia
  • Akrajas Ali Umar Institute of Microengineering and Nanoelectronics, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor, Malaysia

DOI:

https://doi.org/10.25077/jif.16.1.13-21.2024

Keywords:

MAPbI3 perovskite , PEAI doping, grain size, absorbance

Abstract

This study aims to determine the effect of phenethylammonium iodide (PEAI) doping on grain size and absorption of the methylammonium lead iodide (MAPbI3) perovskite layer. The MAPbI3 perovskite layer is interesting to study because of its potential application in perovskite solar cells. In this study, the preparation of MAPbI3 perovskite layer with PEAI doping variation using a 2-step spin-coating method. The surface morphology of MAPbI3 shows an increase in grain size with the addition of PEAI doping variation. The optimum grain size is shown by adding 1.0 mg/ml PEAI doping variation, which is 117 ± 1.19 nm with a smooth surface morphology and tends to be homogeneous. X-ray diffraction (XRD) results on Perovskite MAPbI3 showed no difference in peaks with the addition of PEAI doping. However, there is only a slight angle shift of 2 theta, 0.05° at the main peak (110) and (220), so it will not change the cubic structure of MAPbI3 crystal. The ultra violet visible (UV-Vis) graph shows an increase in absorbance of Perovskite MAPbI3 with the addition of PEAI doping in the wavelength range of 400-550 nm. This research is expected to be a foundation for developing more efficient and stable solar cells.

Downloads

Download data is not yet available.

Downloads

Published

2023-09-22

How to Cite

Anla, A. F. H., Dahyunir, D., muldarisnur, muldarisnur, Amrullah, Y. ., Sadikin, S. N. ., Ridwan, J., & Umar, A. A. . (2023). Particle Size Improvement and Layer Absorption of Metil Halida MAPbI3 Perovskite Doping Phenethylammonium Iodide (PEAI). JURNAL ILMU FISIKA, 16(1), 13–21. https://doi.org/10.25077/jif.16.1.13-21.2024

Issue

Section

Research Article

Citation Check